Fisher Labs 1280-X Manual de usuario descargar pdf (Pagina 21)

batteries will eventually only hold a three-hour

charge.

3. Nicads may reverse polarity if discharged too

far and will not recharge. Don’t leave your

detector on and don’t continue to operate it

more than an hour after the battery check tone

goes silent.

The optional 1280-X recharge kit includes (1) battery pack,

(8) nicad batteries, (1) 110v, 60 cycle home recharger and (1 )

12v negative-ground auto cigarette lighter recharger.

110-VOLT RECHARGER

1. Remove and disconnect the nicad battery

pack from the 1280-X Control Housing.

2. Connect the recharger battery lead to the

battery pack.

3. Plug the recharger into a wall outlet and the

batteries will begin to recharge immediately.

4. The small green light in the charger will stay on

during the entire charge cycling indicating that

all connections have been made and the

charger is working.

5. A full charge will take approximately 24 hours.

Do not charge over 48 hours

12-VOLT AUTO RECHARGER

(Use only with 12v negative ground system.)

1. Install the nicad batteries.

2. Plug the charger into your auto cigarette

lighter socket and the small cable into the 1280-X

RECHARGE JACK.

3. The batteries will begin charging immediately.

5. An overnight charge with the engine off may

give only 6-8 hours of battery life. A full charge may

take as long as 48 hours (less with the engine

running). For this reason, the Auto Recharger may

best be used for OCCASIONAL “Booster”

charges (see Recharging, paragraph 2, above).

6. Do not charge over 48 hours.

BATTERY RECHARGING

1 2 ... 16 17 18 19 20 21 22 23 24 25 26

Sin comentarios

Fisher Labs 1280-X Manual de usuario Pagina 21